Precision NCDS1000 Bedienerhandbuch PDF herunterladen (Seite 6)

6. Attach the top of the Yoke to the appendage located on the under side of the Front Axle Support

by first inserting Large Yoke Washer and then inserting Cotter Pin into the hole in the middle of the

appendage. Use a flat head screwdriver to separate and bend the end of the cotter pin. See Figure

7.Slide Wheel onto the extended threaded ends of the Front Axle Support. Secure Wheels with

Wheel Washer and Large Lock Nut. See figure 6

Figure 5

Figure 6

Yoke

Large Yoke Washer

Cotter Pin

Wheel Washer

Large Lock Nut

8. With the Bed turned upside down, attach the Back Wheel Assembly to the Bed by inserting six M8

x 15 Steering Bolts from under the bar first through the holes located on the metal support bars on

the under side of the Bed then into the holes located on both the Left and Right Rear Axle Brace

and also the Rear Axle Support. Next insert Washers onto the Bolts the secure with Lock Nuts. See

Figure 7.

Figure 7

Figure 8

Bed

Rear Wheel Assembly

M8 x 15 Bolt, Lock Nut & Washer

9. Join the Front Wheel Assembly to the Bed by inserting four M8 x 15 Steering Bolts first under the

bar through the holes in the metal support bars then into the holes in both the Front Axle Support

and the Center Front Axle Brace. Insert Washers onto the Bolts the secure with Lock Nuts. See Fig-

ure 8

Bed

M8 x 15 Bolts,

Washers & Lock

Nuts

Front Wheel Assembly

1 2 3 4 5 6

Keine Kommentare

Precision NCDS1000 Bedienerhandbuch Seite 6